Skunk2 Short-Shifter install...
A.D.D. for life
Join Date: Mar 2003
Posts: 522
Likes: 0
Received 0 Likes
on
0 Posts
unbolt the stock shifter from under the car, install the new shifter in reverse order. not too tough. should take less than an hour.
__________________
LOOKING FOR 3rd Gen Integra windshield trim! HELP!!!!
not your typical honda driver...
AIM: kenracer18
LOOKING FOR 3rd Gen Integra windshield trim! HELP!!!!
not your typical honda driver...
AIM: kenracer18
Dr. Doom
Thread Starter
Join Date: Mar 2003
Posts: 27,320
Likes: 0
Received 0 Likes
on
0 Posts
hahaha....i got the stock shifter unbolted and taken out ok. I looked at the hardware the Skunk2 shifter came with, there were 3 or 4 extra peices that i didn't even need; i was like, wtf is all this shit for?. one thing i didn't find out until today was that other shifters reuse the stock bearing. Skunk2 uses it's oun sealed bearings. but as of now, it's installed, didn't take more than an hour. 
