My hub bearings are fucked!!!
S1's MUSCLE RELAXER
Thread Starter
Join Date: Dec 2002
Posts: 3,844
Likes: 0
Received 0 Likes
on
0 Posts
My hub bearings are fucked!!!
ok i need new hub bearings. my question is, can i get hubs or spindals from any civic besides the hf crx? is it better just to go to a junk yard and spend less on the complete hub than go to honda and pay full price like an ass and then pay more just to get them pressed in. im lost here. any info would be good.
__________________
tamparacing.com
go to uneedparts.com i think it is, and fill it out, u'll get atleast 10 estimates on ur parts w/ shipping and all that. that's where i got my prelude suspension pieces.
__________________
Semper Fi
Aim and Yahoo- Inkedupordie
Semper Fi
Aim and Yahoo- Inkedupordie
buy a whole new hub. i know mine for my prelude only cost like $50 for spindle, hub, rotor, and lower control arm.
__________________
Semper Fi
Aim and Yahoo- Inkedupordie
Semper Fi
Aim and Yahoo- Inkedupordie
Buy the bearings from the dealer or whereever, remove your hubs and take them to any mechanic shop with a press, have them press them in and then your'e good...Junkyard hubs may have bad bearings too...
Zee
Zee
__________________
I work too damn Hard...
04 Civic Si
01 Lexus GS300
I work too damn Hard...
04 Civic Si
01 Lexus GS300
engine building &best
Join Date: May 2003
Posts: 11,971
Likes: 0
Received 0 Likes
on
0 Posts
sealed bearings AutoZone 46bucks each, autoAir press them in 25bucks Takes 5mins
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
I just did mine ended up paying like 86 for just one front hub bearing at discount after getting two that did not fit I have no abs BUT my right front bearing is a abs bearing hahahahaha POS!!! had my uncels shop press the bearing
__________________