I have a B18C1 engine and I want to install a Skunk2 intake manifold. My question is, why doesn't everything from my stock intake manifold fit onto the new one? Where does that UFO thingy go? Does it have to go onto the new one? Where does the hose that goes to that UFO thingy go on the new one? Any information you give would greatly be appreciated. Thanks

 

The ufo thingy is for the secondarys in the gsr manifold, you shouldnt need it, all the other stuff, if you have one, use the manual for the gsr and use the diagrams for the b18c5 maniflod, its the same thing.You need a different throttle cable bracket.

 

Where can I get the throttle cable bracket that I need? How much is one?

 

if i'm not mistaken, you need a different throttle cable too

 

i think you could rig the gs-r one up but i dont remember. i did mine with the help of 2 friends. it fuckin sucked. i will never do it agian. use a b16 throttle cable. or a type r. i think they might be the same.

 

I had to get a b16 throttle cable. My gsr was too long if i remember correctly. I think it was under 20 bucks at honda. Damn i drink too much.

 

Ok. Thanks.

 

When do I run the hose that went to the UFO thingy? Where do I put the hose to the fuel pressure? I think that hose goes to the intake manifold. Am I correct?

 

Does anyone know how long the throttle cable is? My friend purchased a Lokar throttle cable from Jeg's.com and he isn't goint to use it. It is 24" lomg. I went to Jegs.com and tried to see if that one would work but they have two lengths. 24" or a 48". Any info would be great. Thanks

 

Call up honda and see how long the throttle cable is but I know it's longer then 2 feet.