I am going to be doing my engine swap this weekend ( finally ), and I have been told I will need to shorten the drive shaft a few inches. so I want to know who in the area is good and what kind of price should I expect? If there is no one in the area or you have used someone really good out of the area how much should I expect on shipping? I need a quick turn around. I will need a place that can cut, weld and of course balance.

the swap is a 95 camaro lt1 into an 80 El Camino. with any luck by this time next week it will be an El Camaro.

thanks for the info

 

precision driveshaft technologies in Clearwater off of Betty lane a few blocks south of sunset point rd! they do it all! Not my place to say what the charge will be!

 

thanks, have you had work done there?

 

Yes! I install overdrive units on the side and take all my Drive shafts there ,and occasion have custom aluminum shafts made!