i have a 89 camaro that leaks gas out the tank were the fillerneck meets...i found out it was really loose when i tugged on it and it came right out..any ideas on how i can seal it back in the hole without having to get it welded on?(no $ for weld cost)

 

i have the tank pulled out already,and the thing is the guy who had the car before me used jb weld and it didnt work too good.

 

I wouldnt skip the cost on getting a good job done on that gas tank.

If you try to ghetto fab it with JB weld, some of in may fall off and block the fuel pump.

That could cause it to starve, which leads to alot higher cost then just getting it done right the first time.