Hey People,

We have an RX-7 in the shop with a single turbo setup. I am looking for some one who really knows these engins.

There is currently a Power FC being used for engine management.

Any help would be grateful.

Bobby

 

Oh, God. I hate PowerFC.
What are you looking to know? I have quite a bit of experience with PowerFC.

 

So you accepted a car into your shop without knowing how to work on it?


O.o

 

+1. My advice is to tell the owner to take it to a good shop that knows what they are doing. 1st Place Engineering would be a good bet.

 

I am helping a friend of a friend out. This car has been to a few shops in the area and has been hacked up.
It started out as simple engine swap. Then we open Pandora Box.

The owner dropped off a brand new engine from Mazda. Come to find out the turbo’s had cracks in them. It was more cost affective to purchase a single turbo set up.

I need some help with the settings with the Power FC. We have tuned Power FC in the past but not a Rotary.

 

Do you have the PFC Commander in the car? I happen to have a PFC manual that I no longer need since I sold the Wankel paperweight. The instructions are specific for an FD RX-7. Come get it.

 

bump for troux helping, out....better go grab that manual and get this fd on the road!