FOX 5 speed crossmember NEEDED
Guest
Posts: n/a
FOX 5 speed crossmember NEEDED
I need a crossmember for a T5 fox body. I don't care if its single hump or double hump. I can really use it quickly so if you've got one, and can come to our meet tonight, I'll give you a reasonable amount plus buy your dinner.
Team Geritol Racing
Joined: May 2001
Posts: 5,759
Likes: 0
If you have the automatic version, just cut the spot welds on the little rings that go around the tube and slide it to the other end and you're all set. I've used the same one with an AOD, a T-5, a Tremec, a C-4 and now back to an AOD.
Guest
Posts: n/a
thanks Tony, but my car came with the A4LD 2.3 auto. this one actually sits in a different set of mounts right behind the usual spot on the chassis. I can't just put the crossmember in the right spot because the mounting points (where it bolts to the chassis) are only about half as wide, so there will be WAY too much slop in there.
Guest
Posts: n/a
WOOHOOOO back in business BABY! I went to Cophers today, found a couple of them. The first one I found for a 5 speed (will be a drop in) was rusted through (northern car). I settled for one from a V6 auto which had to be slightly modded (see Dr Dirt's post above). Well, as I'm walking around, I see another one laying on a fender, and it was for a T5! So now I have a $9.99 drop in crossmember 
I also got some stupid little parts too. Now I've got most of the parts that I need, so I can get going on the final touches
I also got some stupid little parts too. Now I've got most of the parts that I need, so I can get going on the final touches
