Stock 8.8" rear end length, with SN95 disc brake conversion; will they fit? I'm not worried about rolling the outer fender, willing to do that, and/or trim the inside of that portion of the fender. More concerned with front-to-back, and the inside portion of the body area of the wheel well.

Thanks,
-Josh

 

Yes, they will fit... with a lot of massaging. Make sure you have a BFH.

 

What size wheel? You need at least a 10.5" to an 11" wheel and a very low profile like 35....

Also, some radials are wider than others. Nitto makes some "skinny" 315's.

 

That shit would be sick dude. Steam rollers FTW

 

as stated above... every tire company uses a different tape measure!

Nittos are the "skinnys"
BFG is a lil wider.
And mickey T's are the widest....

go figure!

 

What about something like "Sumitomo" lol?! And I guess I should have mentioned, the wheels are 10.5" wide.

 

I'll go halves on this (it was only a matter of time):
- Harbor Freight Tools - Quality Tools at the Lowest Prices

 

I need to rent it as well. I'll donate to the cause

 

There was some guy on here from Orlando that was renting his fender roller... I'll see if I can find that post.

 

https://www.tamparacing.com/forums/f...rlando-fl.html

This post is a year and a half old, so it may not be there any more.