Rear quarter panel question. ( more room for rubbing slicks ).
Thread Starter
You can thank me later...
Joined: Aug 2001
Posts: 36,199
Likes: 0
Rear quarter panel question. ( more room for rubbing slicks ).
Anyone here ever cut the inner lip ( on the outside edge ) off of their rear quarter panels ? I have rolled mine out with a hub mounted roller but my slicks ( not the DR's ) rub the top edge ( on the outside ) of the quarter panel. Some might remember I destroyed a brand new slick because of this rub.
Any other tricks here ? I am thinking if I cut that off it will give me some more clearance and make the metal easier to roll again.
-
Any other tricks here ? I am thinking if I cut that off it will give me some more clearance and make the metal easier to roll again.
-
__________________
9.31 @ 148.12 ( Drag radials, street driven, low boost, no fancy race car shit....
___________________________________________
TR's Official In House Realtor
PM or E-mail Me If you are Looking To Buy/Sell/Rent A Home.
Special TR Bonus For Using My Services. 
___________________________________________
Registered User
Joined: Oct 2004
Posts: 1,333
Likes: 0
mine rubbed also on uneven pavement,, had dave at nbs cut mine, now there's about a 1/8" lip and no more rubbing.. i was gonna have them rolled, but i 've seen where that leaves dimples on the outside..
lives in a glass house
Joined: Jan 2005
Posts: 5,451
Likes: 0
