Quick 302 question (or 2)
Thread Starter
Registered User
Joined: May 2005
Posts: 42
Likes: 0
Quick 302 question (or 2)
anyone know the sizes of the following bolts?
front lowest timing cover bolt on pass side.
Motor mount Nuts (that go into the K-member)
Nuts on the motor mount studs (to the motor)
front lowest timing cover bolt on pass side.
Motor mount Nuts (that go into the K-member)
Nuts on the motor mount studs (to the motor)
__________________
if its too fast your just scared.
if its too fast your just scared.
Registered User
Joined: Feb 2006
Posts: 4,210
Likes: 0
is doing your girlfriend
Joined: Dec 2004
Posts: 7,101
Likes: 0
5/16 coarse should be 5/16-18, 7/16 coarse should be 7/16-14
__________________
Governments are instituted among Men, deriving their just powers from the consent of the governed, — That whenever any Form of Government becomes destructive of these ends, it is the Right of the People to alter or to abolish it
Thread Starter
Registered User
Joined: May 2005
Posts: 42
Likes: 0
9/16 for the mm's btw
rest were correct thank you rep given to both of you
deuce it wouldnt allow me to give you rep---will get you later
rest were correct thank you rep given to both of you
deuce it wouldnt allow me to give you rep---will get you later
__________________
if its too fast your just scared.
if its too fast your just scared.
