napa machining
Thread Starter
is sorta fast
Joined: Dec 2005
Posts: 583
Likes: 0
napa machining
has anyone ever gone with these guys? they said for boring and honing its 176.00 W/O tax. do they do a good job? is there any place cheaper? i am planning to take it there this friday. -thx david
__________________
Project Snowsled
Powered by LT1
Monroe/ Belltech Suspension
2.5" True Duals with Flowmaster 40's
Built 700R4 By: Tim Moye Transmission
CSR Electric Waterpump
Project Snowsled
Powered by LT1
Monroe/ Belltech Suspension
2.5" True Duals with Flowmaster 40's
Built 700R4 By: Tim Moye Transmission
CSR Electric Waterpump
Redneck Racer
Joined: Jan 2006
Posts: 604
Likes: 0
3D Machine in Ybor.
Thread Starter
is sorta fast
Joined: Dec 2005
Posts: 583
Likes: 0
what is their number?
__________________
Project Snowsled
Powered by LT1
Monroe/ Belltech Suspension
2.5" True Duals with Flowmaster 40's
Built 700R4 By: Tim Moye Transmission
CSR Electric Waterpump
Project Snowsled
Powered by LT1
Monroe/ Belltech Suspension
2.5" True Duals with Flowmaster 40's
Built 700R4 By: Tim Moye Transmission
CSR Electric Waterpump
Guest
Posts: n/a
I used to work for NAPA and I've heard and seen some horror stories. Tried the place up the road from NAPA on Florida. Its between Bearss and Fletcher. The guy that runs the machine shop there used to run the NAPA machine shop and was the only one who know WTF was going on.
Shake n' Bake
Joined: May 2001
Posts: 5,422
Likes: 0
ive had stuff dont there and we used to use them back at my old job. sometimes they do good jobs and other times it would go bad, they messed up a lot of heads but it is all warranty anyways. you can only send them heads and not shortblocks, if you send them short blocks it has to be in pieces....
__________________
Redneck Racer
Joined: Jan 2006
Posts: 604
Likes: 0
