C4 +351Wtf....
Thread Starter
Sweet Lincoln's mullet
Joined: Jun 2003
Posts: 667
Likes: 0
C4 +351Wtf....
I was planning on bolting my c4 up to my 351 today but I had a few ?'s
What size bolts/washer do i need to bolt the bellhousing to the block?
What do i torque the flexplate to how many lbs?
anything else i should know before i get this show on the road?
What size bolts/washer do i need to bolt the bellhousing to the block?
What do i torque the flexplate to how many lbs?
anything else i should know before i get this show on the road?
__________________
-Derek-
-Derek-
is doing your girlfriend
Joined: Dec 2004
Posts: 7,101
Likes: 0
I found out the hard way that the C4 bellhousing bolts are shorter than the ones for an AOD. I believe they are 7/16-14. That is a hard size bolt to find on a Saturday after the real hardware stores have closed. home depot does not stock coarse thread 7/16 bolts. ive got a stack of washers under my bolts. The C4s bolts need to be about 1" shorter than the AODs, at least gfor a big bell, not sure if a small bell is different
__________________
Governments are instituted among Men, deriving their just powers from the consent of the governed, — That whenever any Form of Government becomes destructive of these ends, it is the Right of the People to alter or to abolish it
Thread Starter
Sweet Lincoln's mullet
Joined: Jun 2003
Posts: 667
Likes: 0
I found out the hard way that the C4 bellhousing bolts are shorter than the ones for an AOD. I believe they are 7/16-14. That is a hard size bolt to find on a Saturday after the real hardware stores have closed. home depot does not stock coarse thread 7/16 bolts. ive got a stack of washers under my bolts. The C4s bolts need to be about 1" shorter than the AODs, at least gfor a big bell, not sure if a small bell is different
Thank you
__________________
-Derek-
-Derek-
