putting a king cobra clutch in my 90 for the first time.. everythings been going smoothly till i had to put the input shaft back on the bell housing itself.. Just to double check the alignment i stuck the alignment tool back into the clutch plate to see if it was straight.. the clutch plate moves.. Theres nothing holding on to it between the pressure plate and flywheel.. Isnt the pressureplate suppost to hold the clutch plate to the flywheel ?? I might of not pushed the pressureplate onto the dowels all the way. i had a little problem with them at first being in the wrong holes and had to drop the flywheel again. FUckin A think i might of not pushed the pressure plate onto the flywheel all the way? ahh i think i answered my own question thanks