Head Tech Input???
Thread Starter
PORK CHOP SAMICHES!!!!!
Joined: Dec 2003
Posts: 2,840
Likes: 0
Head Tech Input???
Currently on the 351w I have a set of 1969 HIGHLY ported and polished heads with 1.94 and 1.6 valves. I found a local set of Eddlebrock performer RPM heads for about 500 bucks. Are these heads worth the money and time to swap heads??? If not.... what heads do you guys recommend??? Will Trick Flow High Ports work and are they worth it?
351w
.60 over
Hydraulic .550 cam
Forged Ross flat top pistons
H beam rods
Forged Crank
775 CFM Race Demon RS carb
Eddlebrock Single plane - torker 2
351w
.60 over
Hydraulic .550 cam
Forged Ross flat top pistons
H beam rods
Forged Crank
775 CFM Race Demon RS carb
Eddlebrock Single plane - torker 2
__________________
Derp!
Derp!
need turbo stuff,pm me
Joined: May 2004
Posts: 2,728
Likes: 0
the rpm heads have 2.02 valves and they each weigh prolly 20 lbs less than the cast heads, so youre dropping 40 pounds right off the get, and for 500 bucks its like b.o.g.o
high ports are good too
high ports are good too
__________________
IF YOU CAN READ THIS- THANK A TEACHER,
AND SINCE ITS IN ENGLISH, THANK A SOLDIER
"If we ever forget that we're one nation under God, then we will be a nation gone under."
-Ronald Reagan
Florida Cracker Mustang Coupe Whore
IF YOU CAN READ THIS- THANK A TEACHER,
AND SINCE ITS IN ENGLISH, THANK A SOLDIER
"If we ever forget that we're one nation under God, then we will be a nation gone under."
-Ronald Reagan
Florida Cracker Mustang Coupe Whore
Need To Get Quicker
Joined: Dec 2001
Posts: 894
Likes: 0
What do the heads that you currently have on your engine flow?
