please explain.

 

like he said, i dont wanna burst my bubble with a timeslip

 

that's lame.....run N/T. and stay out of the pokie.


$0.02

 

hes the one who wants to race a 13 second car... im not going out of my way to please him

 

yeah, how far should I torque down the intake?


yeah James the sticker has a good grey color to it and it kinda goes with my car !


er I dont have alot of shit done but I got....


3.73's
BBK shorties
BBK o/r H pipe
Flowmaster cat-back with dumps
aluminum driveshaft
competition engineering subframe connectors
BBK specific rate springs
3G alt upgrade
timing at 14 degrees
MSD 6A box
Ford Racing 9mm wires
Blaster 2 coil
March aluminum underdrive pulleys
Smog pump delete
Professional Products Intake
Edelbrock 65mm Throttlebody

 

I'd go 15-18 pounds on the intake bolts.

 

thats more then whats recomended though..

 

Joe has put on a few intakes in his time, including mine.

Just make sure you get yourself some arp bolts, don't reuse the old ones.

 

Heres a link to Edelbrocks web site. Scroll down to the 2nd page and read #6 on the left side of the page where it says torque intake bolts to 15-18 ft/lbs.

http://edelbrock.r-catalog.com/ImgVD/EDE/3821Inst.pdf

Factory Ford intake bolt torque specs are a little bit higher at 23-25 ft/lbs.

What torque specs did they give you with the intake?

 

good thing I talked to you... I was told it was 10..


I woulda posted and asked before I installed it though..


I thought 10 was a little low , actually really low..

think I might do this and a mild cam.... with the intake.. shift up the powerband a bit..