T/W 91 Toyota Cressida RHD 1JZ
Thread Starter
O.G.
Joined: Aug 2003
Posts: 490
Likes: 0
T/W 91 Toyota Cressida RHD 1JZ
Just trying to see what kind of offers I'll get for this thing.
I want money $$$, a classic car or truck(i.e. 1960's and older), or something that's super clean.
If you post something dumb, expect me to be a complete dick to you.
Comes with a full set of the MB weapons that are in the pic below. Also comes with 4 DZ101's
Also come with the 2 AVS wheels in the pic below.
The motor does run, but needs minor wiring finished.
Custom 3" one piece driveshaft with upgraded mustang U-joints(good for up to 600hp)
Huge 24"x12"x4" frontmount intercooler kit...the piping is getting finished at S&R.
The interior is really clean, minus the dash. I don't have the under-dash or center console. But, the front seats are Bride LowMax w/ glitter back!
SPL stainless braided brake lines all around.
Huge mk3 Supra Aluminum Radiator with dual E-fans.
2JZ complete water pump assembly(front and rear half)
Walbro Fuel pump.
New Clutch Slave Cylinder
Braided Line for the Clutch Slave
DriftMotion Aluminum Pulley Kit
Already installed.
It has some kind of Jap lowering springs in the front w/ Tein basics in the rear.
Still needs a downpipe and exhaust. Could also use some new brake rotors and pads...nothing major.
I'm in no rush to sell this, so low ballers can ball somewhere else.
If you have any questions, please feel free to PM me here or email me BeerPanda@gmail.com
Thanks.
I want money $$$, a classic car or truck(i.e. 1960's and older), or something that's super clean.
If you post something dumb, expect me to be a complete dick to you.
Comes with a full set of the MB weapons that are in the pic below. Also comes with 4 DZ101's
Also come with the 2 AVS wheels in the pic below.
The motor does run, but needs minor wiring finished.
Custom 3" one piece driveshaft with upgraded mustang U-joints(good for up to 600hp)
Huge 24"x12"x4" frontmount intercooler kit...the piping is getting finished at S&R.
The interior is really clean, minus the dash. I don't have the under-dash or center console. But, the front seats are Bride LowMax w/ glitter back!
SPL stainless braided brake lines all around.
Huge mk3 Supra Aluminum Radiator with dual E-fans.
2JZ complete water pump assembly(front and rear half)
Walbro Fuel pump.
New Clutch Slave Cylinder
Braided Line for the Clutch Slave
DriftMotion Aluminum Pulley Kit
Already installed.
It has some kind of Jap lowering springs in the front w/ Tein basics in the rear.
Still needs a downpipe and exhaust. Could also use some new brake rotors and pads...nothing major.
I'm in no rush to sell this, so low ballers can ball somewhere else.
If you have any questions, please feel free to PM me here or email me BeerPanda@gmail.com
Thanks.
dd
