+1 Great post agreed 100000%! If that motor isnt treated right, its worst than putting a H22 head on a H23 block or an untuned LsVtec. Not very reliable at all. Get it sleeved, but be prepared to come out of pocket.

 

dont care what it cost......will that solve my problem? will it be good to go?...would it be good to drag?

 

Damn bro, no disrespect but.... One would think you would have done some research before dumping major coin into a project. Keep the above suggestions in mind, but do your own research. Gather your thoughts, figure what you want outta the motor, layout a plan, then follow through. Just my 2 cents........

 

thats how i got the motor it was givven to me.. ive been doing research.. and asking other ppl about it...wondering if anyone knows cause i dont know to much

 

where did you get TI rods tho? and how much did those cost? and are you sure they are real?