fs/ft: 91 Crx W/B16 Swap.Head Work.CTR Pistons.ETC.
Alright, here are the specs on my car, and a few pics.
If I am going to trade, I would like to trade for a 92-95 Civic Hatchback. Let me know if you have a civic hatch. I have all receipts and engine build pics for those who want to see. AIM = Redlineboyzcrx
EDIT: I will trade for a stock Civic Hatch if there is money put on top of the trade.
This car runs Low 13's, capable of high 12's with tuning.

Engine:
JDM B16a SiR Swap
AZ Race Motor Mounts
B&M Fuel Pressure Regulator
Crane Cams Ignition Wires
ITR Throttle Body
Koyo Racing Radiator
RS Akimoto Intake
Skunk 2 Short Shifter
Tanabe Racing Medallion Exhaust
Head:
3 Angle Valve Job
CTR Cams
Hondata Intake Manifold Gasket
KMS Silicon Bronze Valve Guides
OmniPower Titanium Retainers
Port & Polish
Port Matched
Skunk 2 Dual Valve Springs
SuperTech Racing Valves
STR Pro Series Cam Gears
Type-R Valve Cover
Block:
King Performance Racing Main Bearings
King Performance Racing Rod Bearings
CTR N1 Crank Pulley
CTR Pistons
Transmission:
S1 Tranny
ACT Clutch
Fidanza Aluminum 7.5lb Flywheel
Suspension:
Drop Zone Camber Kit
Rear Tie Bar
Rear Strut Bar
Skunk 2 Coilovers
Titan Tower Strut Bar
Tociko HP Shocks
Electronics:
Apexi VAFC 2
Kenji Chipped & Socketed ECU
RyWire Engine Wiring Harness
Interior:
Autometer 5" Tach
Momo Steering Wheel
Memphis 5 1/4" Speakers
Rockford Fosgate 6X9 Speakers
Sparco Race Pedals
Sony Head Unit
Exterior:
Fiberglass Hood
JDM Taillights
Motegi MR7 Rims
Mugen Bodykit
1-386-503-1611
If I am going to trade, I would like to trade for a 92-95 Civic Hatchback. Let me know if you have a civic hatch. I have all receipts and engine build pics for those who want to see. AIM = Redlineboyzcrx
EDIT: I will trade for a stock Civic Hatch if there is money put on top of the trade.
This car runs Low 13's, capable of high 12's with tuning.

Engine:
JDM B16a SiR Swap
AZ Race Motor Mounts
B&M Fuel Pressure Regulator
Crane Cams Ignition Wires
ITR Throttle Body
Koyo Racing Radiator
RS Akimoto Intake
Skunk 2 Short Shifter
Tanabe Racing Medallion Exhaust
Head:
3 Angle Valve Job
CTR Cams
Hondata Intake Manifold Gasket
KMS Silicon Bronze Valve Guides
OmniPower Titanium Retainers
Port & Polish
Port Matched
Skunk 2 Dual Valve Springs
SuperTech Racing Valves
STR Pro Series Cam Gears
Type-R Valve Cover
Block:
King Performance Racing Main Bearings
King Performance Racing Rod Bearings
CTR N1 Crank Pulley
CTR Pistons
Transmission:
S1 Tranny
ACT Clutch
Fidanza Aluminum 7.5lb Flywheel
Suspension:
Drop Zone Camber Kit
Rear Tie Bar
Rear Strut Bar
Skunk 2 Coilovers
Titan Tower Strut Bar
Tociko HP Shocks
Electronics:
Apexi VAFC 2
Kenji Chipped & Socketed ECU
RyWire Engine Wiring Harness
Interior:
Autometer 5" Tach
Momo Steering Wheel
Memphis 5 1/4" Speakers
Rockford Fosgate 6X9 Speakers
Sparco Race Pedals
Sony Head Unit
Exterior:
Fiberglass Hood
JDM Taillights
Motegi MR7 Rims
Mugen Bodykit
1-386-503-1611
__________________
phearable.net
R.I.P DJSTANG. YOU WILL NOT BE FORGOTTEN!!!!
phearable.net

R.I.P DJSTANG. YOU WILL NOT BE FORGOTTEN!!!!
I am looking for like 5000 obo. I am really looking for a trade for a hatch, and depending on what is done to it how much cash is needed on top. I am looking to do a B20VTEC Turbo into the hatch.
NOTE:
I went to the dyno shop the other day, and the guy told me that the stock injectors are not going to be putting out enough Fuel, he said that I need to get some bigger injectors and tune the car with the VAFC 2, he said the car will be even faster and run even harder than it does. Jsut thought I would give a heads up on the siuation.
NOTE:
I went to the dyno shop the other day, and the guy told me that the stock injectors are not going to be putting out enough Fuel, he said that I need to get some bigger injectors and tune the car with the VAFC 2, he said the car will be even faster and run even harder than it does. Jsut thought I would give a heads up on the siuation.
Last edited by Redlineboyzcrx; May 28, 2006 at 05:49 AM.





