1992 Mustang GT For Sale
Well Im in need of the money, so my baby is going up for sale.
1992 Mustang GT-White 5spd with polished aluminum 5 spoke wheels.
-Car has Stalker Fiberglass front bumper and Cobra R fiberglass lift off hood with hood locks.
-New LMM Springs (drop of ~1.5) Kyb shocks and struts all around.
-Caster Camber plates
-Front shock tower brace, connects shock towers and firewall.
-New rear upper and lower control arms with urethane bushings.
-New subfame connectors with seat supports (welded on)
-3.55 gears
-5spd with cobra ratio gearset and tremec input shaft
-Slotted fronts rotors (not sure if you can machine slotted rotors, could use new pads and rotors if not)
-Aluminum Driveshaft
-Stock 302 block, Edelbrock performer RPM heads, AFM B-31 Cam, GT-40 Lower intake, 1/2 plenum spacer, Downs Ford Racing Box Upper (makes great high rpm power)
-70mm T/b and spacer- Polished aluminum cold air intake (fender-mount)
-stock mass air sensor and stock injectors/computer
-Ford Motorsports wires
-high output alternator conversion (130A compared to stock 80A)
-New waterpump
-New timing chain set done with motor work.
-1.6 ratio Comp Cams Roller rockers
-Hardened pushrods
-MSD 6al ignition with 5800rpm rev limit
-BBK Adjustable Fuel pressure regulator
-Walbro 255lph fuel pump (new filter installed also)
-Cold fusion NOS setup. Used a couple times and haven't since. 125 shot. Should be tuned with NOS before used anymore.
-New ALuminum Radiator and 160* thermostat. Running on I-75 with the A/C blasting, Temps dont rise above half-way mark.
Interior
-triple guage pod on A-pillar. Removed the guages I had in them
-5" tach and shift light
-All factory guages work except speedo is off due to gear change in rear end.
-COLD A/C
-Awesome stereo, I am sad to see this setup go. Door and rear speakers are amplified, tweeters in dash and 10" sub in rear. Awesome sound quality.
White face guages (aftermarket, guage lights quit working except needles.)
Seats have lumbar control
Overall I love this car. It makes great power on the dyno and runs hard on the street. I hate to sell it but I need the money and a truck. Im sure there is alot I haven't listed. I was also gonna swap to a C4 tranny. I have a good tranny, convertor, bellhousing, hurst shifter, cooler. Everything thats needed for the swap except cooling lines. Also, the C4 tranny is stock because I was gonna have it built before using, which is still a good idea. All this will be included with the car. I also have another upper intake as well as a complete fuel injection wiring harness, sensors, intake, T/b and all that will go with it for parts. Car will need new rear tires pretty soon as these are wearing down.
If interested, call me at 239-293-2479 or email me stryker2002@hotmail.com and I will get in touch with you. Im asking $6500 for the car with all the extra stuff.
Car runs great on the road or at the track. Its my daily driver for right now.
Car is located in Naples, Fl
1992 Mustang GT-White 5spd with polished aluminum 5 spoke wheels.
-Car has Stalker Fiberglass front bumper and Cobra R fiberglass lift off hood with hood locks.
-New LMM Springs (drop of ~1.5) Kyb shocks and struts all around.
-Caster Camber plates
-Front shock tower brace, connects shock towers and firewall.
-New rear upper and lower control arms with urethane bushings.
-New subfame connectors with seat supports (welded on)
-3.55 gears
-5spd with cobra ratio gearset and tremec input shaft
-Slotted fronts rotors (not sure if you can machine slotted rotors, could use new pads and rotors if not)
-Aluminum Driveshaft
-Stock 302 block, Edelbrock performer RPM heads, AFM B-31 Cam, GT-40 Lower intake, 1/2 plenum spacer, Downs Ford Racing Box Upper (makes great high rpm power)
-70mm T/b and spacer- Polished aluminum cold air intake (fender-mount)
-stock mass air sensor and stock injectors/computer
-Ford Motorsports wires
-high output alternator conversion (130A compared to stock 80A)
-New waterpump
-New timing chain set done with motor work.
-1.6 ratio Comp Cams Roller rockers
-Hardened pushrods
-MSD 6al ignition with 5800rpm rev limit
-BBK Adjustable Fuel pressure regulator
-Walbro 255lph fuel pump (new filter installed also)
-Cold fusion NOS setup. Used a couple times and haven't since. 125 shot. Should be tuned with NOS before used anymore.
-New ALuminum Radiator and 160* thermostat. Running on I-75 with the A/C blasting, Temps dont rise above half-way mark.
Interior
-triple guage pod on A-pillar. Removed the guages I had in them
-5" tach and shift light
-All factory guages work except speedo is off due to gear change in rear end.
-COLD A/C
-Awesome stereo, I am sad to see this setup go. Door and rear speakers are amplified, tweeters in dash and 10" sub in rear. Awesome sound quality.
White face guages (aftermarket, guage lights quit working except needles.)
Seats have lumbar control
Overall I love this car. It makes great power on the dyno and runs hard on the street. I hate to sell it but I need the money and a truck. Im sure there is alot I haven't listed. I was also gonna swap to a C4 tranny. I have a good tranny, convertor, bellhousing, hurst shifter, cooler. Everything thats needed for the swap except cooling lines. Also, the C4 tranny is stock because I was gonna have it built before using, which is still a good idea. All this will be included with the car. I also have another upper intake as well as a complete fuel injection wiring harness, sensors, intake, T/b and all that will go with it for parts. Car will need new rear tires pretty soon as these are wearing down.
If interested, call me at 239-293-2479 or email me stryker2002@hotmail.com and I will get in touch with you. Im asking $6500 for the car with all the extra stuff.
Car runs great on the road or at the track. Its my daily driver for right now.
Car is located in Naples, Fl
the speedo is off as in ... doesnt work.. or off as in inaccurate speed?
sounds nice.. have pics?
sounds nice.. have pics?
__________________
Torch Red SS 6 speed
Euro Red MR2-T 5 speed

2000 Si FS $3000 buy me! buy me! buy me!
Torch Red SS 6 speed
Euro Red MR2-T 5 speed

2000 Si FS $3000 buy me! buy me! buy me!
The one time I ran it at the track, it was 1/8 with street tires. ran consistent 8.39@89 with a shitty 2.0 60ft. Since that time, Ive done upper intake, throttle body and spacer, MSD, Fuel pump, adj. regulator, rear control arms(to help 60ft), radiator and the NOS. With the changes and a tire I was expecting low 7's on a small shot.
I made a dyno pull on the same setup that ran the 8.39 and it made 276 rwhp and 326rwhtq. I am also expecting closer to 300rwhp and 335rhtq since the mods I made.
Im buying a truck, thats why my baby has to go.
I made a dyno pull on the same setup that ran the 8.39 and it made 276 rwhp and 326rwhtq. I am also expecting closer to 300rwhp and 335rhtq since the mods I made.
Im buying a truck, thats why my baby has to go.







