Yea everything looks the same. What's up? As if you didn't already know the mods here you go.

JDM B16A with LSD
Rebuilt head
Mugen low temperature thermostat and thermo switch
MSD 6A ignition with manual timing controls
MSD HVC coil
MSD cap and wires
Skunk2 intake manifold
DC Sport intake pipe
Greddy 4-2-1 header
Apexi N1 exhaust
255 lph Holley fuel pump.
Nitrous Express EFI Stage 1 kit
Remote bottle opener
TPS activation sensor (not installed)
Full A/C
ACT 6 puck solid disk clutch
ACT 12lb flywheel
Skunk2 short shifter and knob
AEM fuel pressure regulator
Koni adjustable shocks
Nuespeed Integra TypeR race springs
Tanabe front upper and lower tie bars
Tanabe rear upper tie bar
Skunk2 adjustable camber kit (not installed)
Falken Hanabi 15x7 wheels
Nitto 450 Extreme 205/50/15
Brembo slotted rotors front
AEM brake pads
Sparco Monza driver and passenger seats
Sparco harnesses
Autometer monster tachometer with shift light
Pioneer CD player
JL Audio mids and highs
JL Audio amp
Aftermarket headlights
TypeR front lip, grill, and rear valence (not installed)

 

is that a real OEM type r grill you have with it and what about the rear lip

 

no it's a knock-off set from Islandmotorsports,

 

Has it been sprayed yet, how much would you take for it without the nitrous set up?

 

Nice little car,you should check it out ryan.Buy it with the spray,you can always sell it and make some cash off it.

 

I haven't sprayed it with the new head on it.

 

have you tried to test fit the rear lip? hows the fitment? would you sell just the lip? and is it painted

 

No I never test fitted it. I took it out of the box once when it was shipped to make sure that it was the right part and not damaged.

 

u wanna sell it?

 

Bump.