testing waters:88 crx si
Thread Starter
Registered User
Joined: Jan 2003
Posts: 567
Likes: 0
88 crx si
Pics are below
trying to trade my project 1988 crx si. 5-speed It has a non-leaking working sunroof, full interor with a tear in the drivers seat. it is lowered on coilovers and has a 2.5 inch exhaust. the car is painted 2000 si blue, but the paint is lousy and should be redone.
whoever had it before me tried to fill in the door guards for a smooth body line but didnt do a good job. other than that i hit a curb in the rain one day and either bent the upper or lower controller arm cause it now has positive camber on the passanger side. The car runs good, its my daily driver, so im looking to trade it for another running car.
the engine in the crx is an un-mini-me swap with a 1994 d16z6 block with 92,000 miles, a d16a6 head with 121,000 miles, and a dx tranny with no grinds with about 100,000 miles on it, this head/block combination yeilds a 8.66 compression ratio(good for boost, but lousy N/A)it has the power of a HF right now. also installed is a blockguard, new timing belt, new water pump, new cv joints, and new headgasket, new alternator belt. it has no A/C and no power steering. i built this engine combo for boost. Also i have an almost complete turbo kit for this. this is what i have for the kit so far. it may or may not be included depending on the car for trade.
14b or t25 mitsu turbo
HF manifold
adapter plate
02 housing
exhaust manifold gaskget
hf manifold to adapter gasket
adapter plate to turbo gasket
all new grade 8 bolts for turbo,adapter plate, and manifold
coolant lines with brass fittings for turbo
brass fitting to attach oil feed line to oil sender
oil feed line
oil return line with gaskets
oil pan with gaskets(elimantes down time)
mitsubishi 1g bov
misc. intercooler piping
o-ring clips for intercooler piping
starion front mount intercooler
dsm 450cc injectors
jackson racing fmu
holley 255 lph fuel pump
msd 6al
msd blaster 2 coil
autometer boost guage
all you'll need is an a/f guage, guage pod, and performance clutch(cause stock wont cut it!) and No i will not part turbo system out. Looking for trades only, it has a clear florida title and is my daily driver. pics upon request.
trying to trade my project 1988 crx si. 5-speed It has a non-leaking working sunroof, full interor with a tear in the drivers seat. it is lowered on coilovers and has a 2.5 inch exhaust. the car is painted 2000 si blue, but the paint is lousy and should be redone.
whoever had it before me tried to fill in the door guards for a smooth body line but didnt do a good job. other than that i hit a curb in the rain one day and either bent the upper or lower controller arm cause it now has positive camber on the passanger side. The car runs good, its my daily driver, so im looking to trade it for another running car.
the engine in the crx is an un-mini-me swap with a 1994 d16z6 block with 92,000 miles, a d16a6 head with 121,000 miles, and a dx tranny with no grinds with about 100,000 miles on it, this head/block combination yeilds a 8.66 compression ratio(good for boost, but lousy N/A)it has the power of a HF right now. also installed is a blockguard, new timing belt, new water pump, new cv joints, and new headgasket, new alternator belt. it has no A/C and no power steering. i built this engine combo for boost. Also i have an almost complete turbo kit for this. this is what i have for the kit so far. it may or may not be included depending on the car for trade.
14b or t25 mitsu turbo
HF manifold
adapter plate
02 housing
exhaust manifold gaskget
hf manifold to adapter gasket
adapter plate to turbo gasket
all new grade 8 bolts for turbo,adapter plate, and manifold
coolant lines with brass fittings for turbo
brass fitting to attach oil feed line to oil sender
oil feed line
oil return line with gaskets
oil pan with gaskets(elimantes down time)
mitsubishi 1g bov
misc. intercooler piping
o-ring clips for intercooler piping
starion front mount intercooler
dsm 450cc injectors
jackson racing fmu
holley 255 lph fuel pump
msd 6al
msd blaster 2 coil
autometer boost guage
all you'll need is an a/f guage, guage pod, and performance clutch(cause stock wont cut it!) and No i will not part turbo system out. Looking for trades only, it has a clear florida title and is my daily driver. pics upon request.
Last edited by importeclipsegst; Aug 18, 2004 at 09:04 AM.
