If I get on it, it will start cutting out at 60 mph

Reply Subscribe

Thread Tools

Jan 19, 2017 | 03:15 AM

#1 (permalink)

senor honda

Thread Starter

Registered

Joined: May 2005

Posts: 104,522

Likes: 21

If I get on it, it will start cutting out at 60 mph

Ken Price
2000 HD FatBoy, carbureted, stock, 50K miles. If I get on it (coming down a ramp to the interstate) it will start cutting out at 60mph. If I slow down below 60 it runs fine. If I speed back up it will start cutting out at 60 again.
If it is sitting still and I rev the engine up, it runs fine until I get to the RPM that would have been 60 MPH. Am I starving the carburetor, fuel pressure, timing? After sitting for a while, it runs great – even above 60MPH. This seems to be an intermittent problem. But, if I get on it again, I have the same problem.

__________________
Here is the listings of ALL New Mexico Car Events Including Route 66 Anniversary
https://www.tamparacing.com/forums/t...ar-events.html
Top Car Club Meetings? Click a city
Got a video? Email it to Bobfixesitup@yahoo.com
________________________________________________

Keystone Motor Club (Founded 2012)... Free car show Every 3rd Saturday, newsletter is
https://www.tamparacing.com/forums/e...-car-club.html
Keystone picture gallery is here:
https://carstoshow.com/eventdetails.aspx?eventid=93202

Veterans and Friends on First Saturday...Some pictures....
https://carstoshow.com/registerevent...eventid=102331

Port Richey Rod Run at Coast Buick GMC
https://carstoshow.com/registerevent.aspx?eventid=99114

50's Diner US19.... A Florida Attraction.
1730 US-19, Holiday Fl 34691 click: https://www.tamparacing.com/forums/t...acing.html CHRA sanctioned cruise-in.
Cruise-In; Free; Every Saturday 5-8PM plus 10% off the whole menu to cruisers
50's Diner pictures are here: https://carstoshow.com/eventdetails.aspx?eventid=93194

All Cars Every 2nd Saturday Free Breakfast: Since 2015 and more. click: https://www.tamparacing.com/forums/e...ast-tampa.html

Tampa Racing.com covers the Tampa car scene and supports many fund raisers, worthy causes and events that enrich our community. We hope you enjoy them all.
What do I do? ---- on-site *Aftermarket* spring/suspension installations --- on-site impact wrenching---street lowering with your own stock springs...........True Bi-xenon HID projector headlight conversions........ Much more at Bob's Garage!
https://www.tamparacing.com/forums/b...ontact-us.html
https://www.tamparacing.com/forums/b...e-senor-honda/

Jan 19, 2017 | 03:16 AM

#2 (permalink)

senor honda

Thread Starter

Registered

Joined: May 2005

Posts: 104,522

Likes: 21

Customer Service Techs
There are a number of things that can cause this issue.
Yes, you can be “starving” your carb for fuel. Check your float height and before moving on, verify that nothing is interfering with your needle valve & seat.
Inspect your intermediate (slow) jet & main jet. Make sure nothing is blocking their passages.
Inspect the condition of the diaphragm on your slide. Check for pin holes or tears.
Check for an intake leak. If intake seals have not been changed in a while, they may be due.
Check for a vacume leak.
Also, make sure that your gas caps are venting and that your fuel line is not kinked, or collapsing.
If you still have your stock vacume fuel valve, you may want to consider replacing with a OEM replacement, or Golan fuel valve.