is this a bad idea
Registered User
Joined: Jun 2006
Posts: 1,593
Likes: 0
Make sure you round over all the corners though!
__________________
Need anything installed or built? PM me.
MECP Certified.
Alarm: Viper 5200
HU: Stock
Active Set-Up
Tweets: Image Dyamics CD1pro mini horns
Mids: Sundown Neo Pro 8s
Amp: Kicker IX500.4 (2)
Sub Stage
Subs: (2) Dayton Audio 15" HF
Amp: Kicker IX1000.1
Need anything installed or built? PM me.
MECP Certified.
Alarm: Viper 5200
HU: Stock
Active Set-Up
Tweets: Image Dyamics CD1pro mini horns
Mids: Sundown Neo Pro 8s
Amp: Kicker IX500.4 (2)
Sub Stage
Subs: (2) Dayton Audio 15" HF
Amp: Kicker IX1000.1
isuck
Joined: May 2010
Posts: 491
Likes: 0
what?
__________________
LOGIC? You seriously want to invoke logic in a conversation about fake hijackings, missiles hitting the pentagon, and bombs planted throughout the world trade center? I thought it was a given that logic was checked at the door when entering one of these threads.
Now there's some logic!
isuck
Joined: May 2010
Posts: 491
Likes: 0
pour the fiberglass and "paint" it all on the inside of the box, this will make it even more solid and airtight. Then you can paint the outside of it just fine.
__________________
LOGIC? You seriously want to invoke logic in a conversation about fake hijackings, missiles hitting the pentagon, and bombs planted throughout the world trade center? I thought it was a given that logic was checked at the door when entering one of these threads.
Registered User
Joined: Feb 2004
Posts: 783
Likes: 0
i use spray polly. mdf seems to suck up primer like a sponge. and with a good urethane primer it can get expensive. coating it with fiberglass resin works excellent too just a little harder to sand smooth. you can also mix some bondo in with some fiberglass resin, mix it up to a good sprayable viscosity, add mek hardener and spray it out of a paint gun. it will lay flat so less sanding, and easier to sand than just straight resin, kind of a poor mans spay polly
