yea i dont understand any of this :-?

 

you will be the same going in to the amp the only way you change the ohms is the wireing ong the subs its the same if you put it in one chanel or if its dirdged, because you only have 1 wire going in to the box it wont change

 

WHOOPS......mad stoner error....i typed in 4 sVC subs.

I MENT 3 ........yes 3 SVC 4ohms in paralell.........to 4/3ohms = 1.333333333333333............ohms

my bad, .....one of those moments.....

 

.......so yes now 1pos. and 1neg. onto a 2 channel bridged into mono............

 

ok the subs are wired to 1.33333.. ohms you have 1 positive and one neg. when you put it in the amp no mater what chanell you use it wont change the ohm's you can bridg it or run it on one chanell it wont change

 

but it we had 2pos and 2 neeg it would halve the ohm load correct?

 

i dont kno to much about all that so can someone explain it to me in dumbass terms lol..wut exactly does bridging do? and how do u do it?

 

Did you ever get your positive and negative wires man?

 

lmfao not yet...

 

good lord...... 2pos 2 neg ........does the amp see half the ohms on a 2 channel amp and/or a mono amp......