Make sure always check oil. I spun a rod bering in my motor about 1 month ago, but the good news is that its being replaced by somethin better.

 

Definate bummer about the engine blowing. Should we assume by 'something better' you are dropping in 2.5L shortblock?

 

or maybe a closed deck EJ22 with forged internals

 

well its a 2.5 short block, cp pistons, JE rods, fully balanced crank, .303 bored over, 680cc PE injectors with rails, UTEC, PE 18/20, Coastal custom exhaust manifold, Up graded clutch and Fly-wheel, Rotora Big Brake KIt, STI seats(front and rear), Sti intake manifold, GFB pulley set, walbro fuel pump, HKS high Power exhaust ,helix down pipe, MRT up pipe and tranny will be on its way shortly after.

 

how much and where did u get the 6spd tranny?

 

Somehow, it's hard for me to feel bad for your original post after that

 

Well what im actually goin to order is MRT gear set they go for about 3000$ it should hold the amount of power im goin to be puttin down

 

well the power is goin to be all up to tunnin, Sam should be able to atleast get 350 or better im wish 450 near 500. I wanna get the full dog box but i have to see how my fanacial status is by then