Step 3: Remove old filter
There are tabs on either side of this cover that are released by squeezing them inward. Once the cover is removed, pull the old filter out slowly—it’s likely to be full of dust and dirt.
Step 4: Clean the filter housing
Check the filter housing for excessive dirt or debris, and vacuum it out if necessary.
Step 5: Slide new filter in
When you go to put the new filter in, check the airflow arrow on the edge to make sure you’re getting it in place properly. Once it’s seated securely, replace the cover and snap it into place.
Step 6: Put glove box back
Lift your glove box back to its original position, and secure it by sliding the pin back into the hole in the arm, or putting the band back in place. Then, replace the screw, close the glove box, and you’re done.