Just an update on progress so far.Got the rear assembly in place. Not fun, but complete. When measuring out if it's straight or not, I measured from the sway bar end link (lower bolt) on both sides to the rear of the trans.
I was dead on, so there wasn't any front to back differences.As for side to side, it didn't change due to the nuts in the subframe are fixed position. So no change there. Dodge did a good job of aligning it right.
Next is the front subframe. I'll be doing the same triangulation once it's in place. It's been a fun job. But definitely an improvement. The prothane bushings in back has stiffened up things tremendously. The car has a much better launch with no wheel hop this time. Can't wait to get the front end done so it's all this way.