So, I am 80% sure about this. Just seeing the interest before I go ahead and pull everything. I want to go LSX, then turbo down the road. I will snag a video of the car running tomorrow so you know you are getting quality parts.
Location: Tampa, Fl
Paypal only. Prices do not include shipping. I am very reasonable with shipping prices. PM me if you are interested, but please don't be ridiculous.
** A lot of these parts are pictured in my build thread when I bought them. Message me and I will get you a specific pics if needed. 95 percent of them have 200-300 miles.
$ 200 96' KA complete no a/c compressor/exhaust/ or fuel rail I do have the injectors though, if needed I can track down a rail. Everything else is there. Recent oil change, valve stem seals were changed 300 miles ago, new lower timing guides. New OEM thermostat. Motor does not miss a beat.
$550 DIYPNP megasquirt
-Fully assembled! Every circuit was soldered, even ones not needed. A/C is fully functional. It is in my car running now. So I can grab a video if needed.
-Already loaded with firmware
-Launch control has been setup
Includes:
DIY Auto Tune Serial to USB cable w/ driver disc
24-1 Trigger wheel
GM Air Temp sensor
GM Coolant Sensor
Desktop power supply
Tuning Book by Matt Cramer and Jerry
* Not sure if I can transfer my full version of Tuner Studio, but I will if I can. Has VE ANALYZE Autotune.
$50 oil pan with -12 AN bung welded in ( A/C friendly). Will also include for $30 more my -12 ninety degree push loc fitting. I will also include my push loc turbo drain which is a -12 straight, comes fits my HX40. Should fit gt35r,6262's etc etc. Please go price all that out.
$35 64" -4 oil line with adapter block. It allows you to screw into your factory oil pressure port, screw on your stock pressure sensor with two accessory ports.
$60 fuel rail OBX fuel rail 1 month old.
$200 1200cc RC injectors. Brand new O RINGS, 11mm tops. Pig tails included. Perfect working order. Just flow tested and had the dead times tested for you standalone users.
$150 Aeromotive FPR. Includes optional 0-100 psi gauge and three -6AN fittings. Good for 1000 hp, very compact. 1:1 rising rate. Maybe a month old. I may also include my 5/16 barbed fittings for you guys running stock lines. Paid $250 total for everything.
MEGASQUIRT
Turbo with new housing and feed/drain. ( Turbo has been used so housing has use)
Random pictures of some parts listed.
NEW AEM wideband/Innovate Boost gauge/ Tial wastegate
Clutch before use
6 puck unsprung
11 LB Flywheel:
Manifold before use
