Got all the center console and gauge/ac aontrol cover off and have been testing continuity but my book (haynes) isn't very specific. From the photos attached you can see what I mean.

[ATTACH=CONFIG]183643[/ATTACH](book doesnt mention pin 6 but it was giving continuity on ALL settings)
The 1 to 4 fan speed switch have proper continuity, now checking the positions the book says in "heat" and "vent" positions which I would think means recycle air flow (use inside air) or outside air the temperature control knob to the hotter position as shown in the picture below, but I'm not sure if that is correct.

[ATTACH=CONFIG]183642[/ATTACH]
I tested the fan position switches and they gave the following continuity
1. 2 to 6 (all upper)
2. 2, 5, and 6
3. 2, 6, 14 (all lower)
4. 2, 6, 13
5. 2, 6 and 12 (all defrost)

Is the 6 pin for heat? (as is popped continuity for all)

Also cannot find in my haynes book or online the location on the A/C pressure switch. I read it was somehwhere behind the gauge cover but I'm not sure.