IF it is the tranny, that will not work. It is a grounding thing with the ecu/engine/tranny. i would loosen the tranny bolts, make sure there is a good contact between bellhousing and block and tight the crap out of them.
Originally Posted by
97mustanggton18s
Well today I took some jumper cables from the engine to the battery for the ground...still no spark. I cant seem to find where the ignition relay is to swap it with a known good one. I pulled back a small section of the wire loom and didnt see anything with the wiring harness, but then again I didnt inspect it that much.Im still trying to figure out what im going to do as of right now.