Thanks.

Unfortunately didn't get too much done this weekend. I still have to finish the harness and get some starter bolts and then it should be ready to start...save for getting some fuel.

Got the header on after having to bore out the ports on the manifold gasket.



Set the PWJdm Strut tower in place but I don't think it's going to work. It doesn't clear my fuel rail.




Got the steering setup put on to help maneuver the car when I roll it in and out of the garage.



That's about it. It's going on jack stands to get my extended wheel studs and new wheel bearings installed, along with new hardened rubber bushings for the front LCA's