Thread
:
Fully Built SR20 (S14) in a 350Z using drive-by-wire and dual ECU's
View Single Post
11-08-2011, 03:04 PM
#
3
(
permalink
)
Z Fever
Registered User
Join Date: Nov 2003
Posts: 45
Likes: 0
Received 0 Likes on 0 Posts
We have finally built the engine and are getting ready to install into the chassis. Here are pics of the engine build:
Installing the Supertech springs and retainers
The powder coated S14 valve cover. It is polished then black satin coated
Now we are putting the bottom end together with all new pistons, rings, main bearings, rod bearings, ARP's and metal head gasket:
New performance oil pump gears:
Then we installed the front timing cover:
Then we installed the ARP head studs, Cosworth head gasket, and cylinder head. Along with in the intake manifold, valvecover, and custom made exhaust manifold:
I will post more pics after we get the engine set in place and start building the custom engine and trans mounts...
__________________
Z-Fever, Inc
4715 N Clark Ave
Tampa, FL 33614
813-877-7600
Doug Mitchell, Owner
Email:
doug@zfever.com
www.zfever.com
www.VQ35swap.com
Last edited by Z Fever; 03-26-2012 at
05:08 PM
.
Reply
Like
Z Fever
View Public Profile
Visit Z Fever's homepage!
Find More Posts by Z Fever