I am rebuilding an 88 TurboII. I have been trying to hunt down a descent (original) swap to put into the car, but Ive had no luck just yet.

So basically I have an 87 NA 13b going into it. The engine has higher mileage, but its a full running swap that I took out of my 87 GXL.

While I have it out.. these are the things I am looking to change/eliminate/fix.

1. Oil squirters.. How "simple" of a task is this. I am aware that I will have to premix my fuel after, but
what are the pros/cons and pains about removing the setup.

2. What are the sensors/wires on the side of the trans.. I know that one has to be the shift light
sensor and the mechanical speedo is down there too, but im unsire of the 2 sets of wires that are
on both sides of the tranny.

3. Is it possible to run a periphial port style intake on an engine that has not had a port job. I have a
friend that can fab alot of things and I was wondering if this would be any benificial to "opening" up
an NA car.

Any help, insight or ideas are greatly appreciated..

Thanks.
Bryan