So being that this is my first build thread I will try to be as detailed as possible, hopefully I do not leave anything out but please ask any questions you may have! As the build progresses I will update the thread


Why a 2.4 Long Rod? Well I wanted to try something new, I love torque and love the fact that I can spool quicker on the motor.
What Compression Ratio? I am going with a high compression 10.5.1 motor on E85. I think this combination will be ideal for a well-rounded powerhouse.
What Internals? We went with the Manley Turbo Tuff I-Beam Rods and Manley Pistons, the block was clearanced - Stock crank was balanced and polished with ARP Mains to bolt it all together




First things first - Here are some shots of the motor out of the machine shop:




The block was hand washed after bringing it back to the shop:



Engine Blood



Prepping with Bearings and Studs:




Apply Sauce:




Crank In:





Shot of the Pistons and Rods Pre-Install





Some Shots Before/After the Pins are Installed And Having Some Fun





Apply More Sauce and Connect



GO INTO YOUR HOLE!



Two Down



All In! (That's what she said)