This made a sticky on sfldrifters...

Mods Please Sticky
What: Homemade Engine Mounts
Why: Alternative to Hockey Pucks, Nismo Mounts or Stock Mounts
Time: 1 hour

Tools Needed:
Drill with 3/8th Metal Drill Bit
Table Saw or Hand Saw
Tape Measure
Chalk

Materials Needed:

1 - Tube of super glue
2 - 16oz Rubber Mallets


1 - 2ft length of 3/8ths all thread
4 - 3/8ths Nuts
8 - Washers (only 4 pictured)




Step 1
Take your drill and drill a hole straight through the rubber mallet width-wise.
(there's metal in the middle so make sure you have the proper bit)


Step 2
Then Cut the handles off


So they look like this


Step 3
measure the rubber and cut off rubber it until it measures 3 inches
(you can go smaller to lower the motor if you have clearence issues)


like so


Step 4
Cut 2 5&1/4inch lengths of all thread


Step 5
Super Glue your washers around the holes on the rubber


Step 6
Push your 5&1/4inch lengths of all thread through the rubber


Step 7
screw nuts on each side

Final Product


i chose to leave them bare, you can also wrap them in heavy duty tape or what not.