Thread: NEED help again
View Single Post
Old Apr 13, 2011 | 06:47 PM
  #4 (permalink)  
Tony@1320Motorsports's Avatar
Tony@1320Motorsports
Registered User
 
Joined: Jul 2008
Posts: 156
Likes: 0
Default

Originally Posted by Superwes98
thanks hurst, ill have to get a start button from work tomorrow

so u think it could just be timing related?
I agree with Hurst on this one...Sounds like the Dizzy is off which is causing a valve to be open at the wrong time when it should be closed which is then allowing the piston to push the compressionn into your intake manifold causing the burst of air your hearing which inturn is blowing off the vacuum line(s) at the intake manifold.

Also BTW:

All you need to wire a remote starter is Either a Toggle switch or momentary switch & 2 Pieces of wire a few feet in length to give you some slack.

Connect the 2 wires to the starter solenoid...I like to use an Ring terminal held on with a nut if you dont have the right size nut then aligator clips or close pin could work aswell to hold the terminals on the post....Then touch the other ends of the wires together to make sure the car turns over then go ahead and hook them up to your switch and bump away!!

Good Luck with it!

-Anthony-
__________________
Anthony & Ryan @ OverKill Performance
Victor @ A&E Motorsports
Jermey Martorella @ UPR Products
Tim @ MPR
"Red Rocket" NMRA EFI REN 4124
Reply