Old Apr 13, 2011 | 06:33 PM
  #1 (permalink)  
*Rotary Addict*'s Avatar
*Rotary Addict*
Registered User
 
Joined: Apr 2011
Posts: 3
Likes: 0
Thumbs up Mazda rx-7 fast street/drag!!!or trade for clean daily driver!!!$5,700

1985 Mazda RX7 up for sale! OR "Trade for clean daily driver". I have invested a lot of time and money into this car!! YouTube - Piston Vs Rotor
[ATTACH=CONFIG]152673[/ATTACH]
This street driven RX7 12A runs low 11s in the quarter mile and low 7s in the 1/8 of a mile. RX7 is registered and can be driven to the track, all you have to do is change the tires to slicks (which is included with the car) The car is no where maxed out and has much more potential with more nitrous. (making it run in the high 10s in quarter mile and high 6s in the 1/8 of a mile).ALSO NEW LINE LOCK SYSTEM & "513" POSI GEARS FROM MAZDA COMPETITION Cost me $700.00!!
-new 12A full bridge port motor with only 900 miles on it
-all heads and housings were resurfaced
-all new gaskets (new black superseal APEX)
-endplay was measured
-all specs were done right, including engine balance
-exhaust on housings fully ported
-runs strong and starts right up
-racing beat intake with holly 750 carb, modified
-NOS cheater kit (NOS system includes 2 ten pound bottles, nitrous pressure gauge, fill station to fill your own bottles, and all nitrous and fuel jets
-Fuel system
-holly black pump for carborator
-holly blue pump for nitrous system
-all AN6 braided fuel lines NHRA approved
-in line metal fuel filter
-seperate fuse box for pumps and NOS kits
-all solid motor and transmission mountings
- racing grant steering wheel
- new brakes/ wheel barrings
-brembo rotors
-new autometer gauges(water temp, fuel and oil pressure, monster tack, and pyrometer)
-racing beat spark plug wires and NGK spark plugs
-MSD racing coils
-2 MSD 6NL boxes with wires all professionally done (includes different rev chips)
-racing electric fan with bolt in thermostat
-oil catch can with breather filter
-battery relocated in back hatch
-NHRA approved vented diamond plate box with moroso kill switch
-racing headers with full exhuast 3.5 inch piping with side cut out for the track and baffle for the street
-all lights and gauges work on this car including volt/amp gauge (custom aluminum dash and doors)
-never been in a crash
-bottom of vehicle is straight, like it came from factory

For more information plaese contact Tony at (407)-350-7164 (buyer can only test drive if they have money in hand but I will start the car for whom every wishes to hear it run)
[ATTACH=CONFIG]152674[/ATTACH][ATTACH=CONFIG]152675[/ATTACH][ATTACH=CONFIG]152676[/ATTACH]
Reply