ok so i pull my axle 92 teg pass side, go get new one put it in, wont fucking go in all the way i have enough space to put a screwdriver in between the axle and tranny. so i thought maybe wrong axle so i pulled the axle from my civic with teg swap try to put that one in the teg, same shit goes in but stops 1/8 inch or more away from the tranny, pulled seal still wont go, . at this point i have no friggin idea what to do, 3 differant axles all the right ones wont go in. can u tell me something that might point me in the right direction i even stuck a magnet inside to look for old snap rings and burs got nada. i bought the car with a busted cv. . also when i got it the cv was really really really hard to get out and when i got it out it looked like a driver side cv it was splined all the way down on the shaft and on the pass side its only SUPPOSED TO be spLined like 1 inch at the end. im totally stumped at this point any help would be appreciated