Time for some updates.
We completed all the aluminum fab work and installed the supplied guages/timers.
Some pics of our work.
From the throttle body going down to intercooler:
out to cooler:
cold side off car w/o BOV:
w/ BOV:
installed:
Typically the hot side charge pipe is run over/across the engine. HOT air rises
So, we decided to take a different route for the cooler routing. We ran the piping under the drive pullies and around the oil pan. The distance ended up being shorter then running over the engine and will also result in lower intake air temps
Also gives a nice clean appearance in the engine bay !
Do to the lack of ports on the intake manifold we had to fabricate a small vaccuum manifold for all our boost refs. We used simple aluminum tubing and gave it a nice brushed aluminum look.
Customer provided all AEM guages, Apexi timer and mounting pod to monitor all engine vitals. Now that all the fabrication is complete it was now time for James to take over and wire everything up !
before pic
during disassembly:
complete:
Thanks for looking !
Proven Power LLC
8602 Temple Terrace Hwy C14
Temple Terrace FL 33637
813-988-3966
2008 Turbo Mitsubishi Lancer GTS