On a different note.. these arrived at the shop today for me =D





I thought this was going to be a drop in install, 10-20 minutes at most. Not.. 6x9s did not fit the stock 6x9 holders. I had to cut out the top piece that was went for blocking water I assume. Looked for the dremel, no where to be founded, soldering iron was my next choice, but then the cutting tip for that was missing. Next choice: hand held hacksaw. It sucked using this thing but it got the job done.






Next step is to finish my box, mount my amp and crossovers. (Staying passive for now). Still need to remount the passenger side horn and work on the mounts to perfection on them. Then I will sand down the horns, repaint them and clean everything up.