I've been doing some research on installing the Z32 MAF that I picked up since I'm getting a few hiccups from mine. I'm sure it's from running without a filter for a few days.

Anyways, I'm really trying to avoid cutting up my harness since I paid a good bit for it from Wiring Specialties. I found that I can remove pins and install them into the Z32 pigtail. Has anyone done this in the past? Also I've read that I am supposed to use a SAFC or a tuned ECU for this setup, is it NECESSARY?

Pin-out that I found:
A - Not used
B - 12v White wire
C - Black ECU ground
D - Ground to chassis
E - 0-5v ECU signal Black/White wire
F - Not used