1. Drain motor oil
2. Jack car up and put it on jack stands
3. Loosen motor mount bolts to the very end of the thread
4. Jack the engine up where the tranny and motor meets all the way up till it stops or starts to raise the car itself
5. Take off oil pan bolts, before you can take out the oil pan, you will need to take off the oil pickup thing
6. Clean off the surfaces where the oil pan and the motor meet.
7. Apply rtv liquid gasket to oil pan surface
8. Install oil pan and pickup and lightly tighten the oil pan bolts, do not tighten them all the way down yet
9. Go get a beer and chill for 30min
10. Now you can tighten the oil pan bolts
11. Replace oil filter and fill oil all the way to max indication on dipstick, start engine and let it run for a couple minutes, turn it off and check oil level again.