Found a issue with my Valve cover gasket so i pulled it off to fix it, and while it was off i noticed something a little peculiar...

Both cam lobes on intake and exhaust on cylinder 3 show a small amount of heat wear, and were basically dry... no other lobes show anything and are fully oiled and clean.

While we were building the motor both oil squiters were very much cleaned out, and checked. the only thing different from the head previously is the metal tab in the exhaust side by cylinders 1 & 2 that you run into when installing the RAS.

now usually i would just think the oil squirters were clogged but the fact that both lobes for cylinder 3 are showing it makes me curious as to if something else is going on that i am unaware of.

any thoughts are appreciated thanks guys