Hey y'all, I don't post up in this thread much but I had some bullshit to fix on my car and wanted to see how many others have had to go through this crap. Why is it that Honda in it's infinite wisdom and leading edge engineering desingned the front hub of my teg so that if a 2 dollar wheel stud breaks off you have to take apart the entire damn thing? I had to pull the hub completely apart and use a torch to heat up the old bearing race so I could get it off the spindle then it was 50 something bucks for the new bearings that have to be pressed back on?!?! WTF honda!!! I mean the back hubs have a sweet spot where you can just bang out the old studs. Seriously, how am I supposed to rep Honda when they do some stupid shit like that?!?!?! Gay. Just gay. Anyways, that's my rant.