OK... U dont ned the colored links.
start by taking valve cover off.
remove timing chain shield.
remove timing chain tensioner.
remove intake cam gear.
remove cylinder 1 (closest to u) spark plug
Put crank on top dead center (carefully) (second mark from left on crank)
make sure piston is at tdc by looking in the hole
set exhaust cam to appropriate position per diagram (minimal chain slack between crank and cam gear)
set intake cam to appropriate position per diagram (minimal chain slack between gears)
tighten back down the gear (dont forget this)
install tensioner
count links between the little circles on gears (20)
set cas and make sure the indicator is pointing to the correct dot
install cas
install timing chain shield
install valvecover
tighten to specs on EVERYTHING
make sure everything is grounded
install spark plug
start car and adjust ELECTRONIC timing thru cas after it has reached normal operating temp
add COOLANT