this is for a B18 stroker motor it was once a 1.8 liter but is now a 2.3 liter this is not a rebuilt block this
block is fresh out of Darton fully sleeved and assembled with eagle crank rods and CP pistons acl race bearings as
well this was made to be as indestructable as they come

aem fuel rail
aem fuel regulator
gel filled fuel gauge (made to keep the needle from bouncing and give acurate measurements)
Darton solid deck block good for 55lbs of boost
CP 8.5 :1 pistons
Eagle H-Beam Rods
eagle crankshaft
ACL race bearings
Spoon water pump
Skunk2 Camgears
Unorthadox racing pulleys 3 PC
MSD Billet distributor system including MSD Plug wires good for up to 14000 RpMs
Comp tech vavles springs and retainers with full port and pollished head and 5 angle valve Job
Skunk2 intake manifold
DH Racing 74mm Throttle body
ARP head studs
eagle head gasket
RC 450 injectors although i do recoment using much larger ones if you decide to put serious boost but you should be good for 30 lbs of them

this engine has all the bells and whistles I will also include a 6lbs fidanza Flywheel and an exedy 3 puck clutch

I was running a gtk 850 turbo on this with aem ems and it was beautiful. my gsxr couldnt keep up with it

everything listed has been in fully running condition only 1500 miles on it I decided to part all of this out after getting a ton of speeding tickets
and a suspended license so goodluck on street driving with this beast lol

if there are any questions please message me i would be happy to answer them

the asking price is 4500 its truly a steal for all the money that is in it I am also willing to take offers and even possibly partial trades