for the boost leak, go to lowes/home depot... go over to the plumbing section and look for a rubber pipe cap... if you have a 3" turbo inlet, get a 3" pipe cap.... then, shoot over to tools, and where are the air tools are, look for the MALE end for a air hose... go home, drill a 1/4" hole in the center of the cap, thread the male end into the hole, clamp down on your turbo inlet...

get a spay bottle of water, put like 10 drops of dish soap in it, shake well...

get your air compressor out, adjust for about 20-25psi, connect to the male end on the pipe cap... then spray all your piping/coupers/clamps/vac lines/gaskets/intake mani...

if there's any leak, you will have bubbles... tighten clamps as needed...




as for the fuel pump, you could be getting proper voltage to it, and it still be bad... thats why i said save it for last...