yes there r many writes on this..the motor will fit with a set of bseries ef mounts"hasport or just a cheap set off ebay" the tb will work fine you will just need to run the map sensor wires longer from your wirewall to the tb,,you will need to hammer in about a 1" where the alt goes to make it fit..you will need many parts from a 90-93 integra such as the drivers side mount post,rear tbracket,obd0 injectors and distibutor,and you will need 94+ integra axles if the crv motor comes with a half shaft and you have to pop out this metal ring around your wheel hubs to tighten the axles down..,you will need a 90-93 shift linkage and have to cut and weld to size of spend the money on a hasport one,you will also need a 90-93 integra cable transmission and 90-91 ecu,....only hope your hatchback is a si..other wise you will need "integra" to build you a harness from your Dx to make it mutiPort to work with the motor good luck with your project