right now... its MT... so MT that my gas light comes on if i brake to hard.

probalby only a few gallons in it right now. I need to do my fuel pump cuz i have a kid whos gonna buy my stocker off me for like Fiddy bux... a turbo Camry project. 5SFTE

i wanna notch or cut off the corner of my gas tank cuz as my exhaust comes under the tunnel in my rear subframe, it dead ends RIGHT at the corner of the gas tank, which requires a drastic 90* to go out to the side, and then another 90* bend to continue going back... not cool. I wanna cut the corner off the gas tank so i can run a smooth 45* after the Subframe and then a 4" axle-back... on a 45* angle of course.

EDIT: im just worried about the fumes being too strong and being a fire/explosion hazard during welding... joo know? they say youre supposed to fill it with water before welding... but its just mild steel i think... dat shitll rust over in half an hour or sooner.