well i actuly had it on here to sell but thnx for the tips guys. ok heres a lil more info.
i pulled the engine out of a running 1990 4door drove it home from tampa... i swithc the engine and trans into my 1993 3 door i used the 93s wireing harness, 93s dizzy and the 93s injectors. i put a skunk to racing intake. All the sensors are pluged in but i keeping getting a bad Air intake temp. sensor but i have replaced it twice now so i know i have a good one. and also i see that by my intake that there is a two wire connector thats unused i think it would go to a sensor in the intake but have no clue what sensor..
its got a new fuel pump also but i still cant rev over 4000 rpms. if i disconect the battery it runs great for a few then goes right back into limp mode. any ideas